Jet washers and toilets are two modern bathroom facilities that are currently used in various types of buildings, such as home bathrooms, apartments, shopping centers, offices, schools, and other public areas. The washer jet is usually installed next to the toilet. This toilet spray with adjustable water pressure is really comfortable to use for rinsing intimate parts and between toilets that are difficult to reach.
This 'toilet shower' is very helpful and makes bathing activities easier for Indonesian people who tend to prefer cleaning themselves using water. It feels less complete if you don't rinse with water after defecating.
However, just like a shower for bathing, this jet washer often experiences several problems if it is not maintained properly. Yes, it's normal to use a jet washer in the bathroom quite often, especially if there are a lot of family members. Click link Below you will find out some of the common problems with washer jets!
However, you don't need to hesitate or worry about switching to using a jet washer in the bathroom. Because there are several practical ways that can be done to overcome this. Anything?
1. If water drips
The most common problem with washer jets is water dripping. Even though the handle is closed, it is possible that water will still drip from the water jet washer holes. Leaks can also occur in the flexible hose that is connected to the tap stop.
If a leak occurs at the washer jet head, it is best to replace it with a new one so that it functions optimally again. If a leak occurs in the flexible hose, turn off the stop tap and remove the flexible hose. Then, reinstall it and make sure it is installed tightly so that there are no leaks.
2. If the water pressure is too strong
Flexible hose leaks can also be caused by too strong water pressure. To overcome this, you need to readjust the washer jet water pressure according to its capacity via the tap stop. Choose a quality washer jet that can deliver high water pressure.
GB Sanitaryware jet washer GBSN10-BM. (Doc/GB Sanitaryware)
3. Slow water pressure
Just like showers, jet washers can also experience slow or weakened water pressure. Usually, this problem occurs because of a dirt blockage in the water filter. There are various causes for the appearance of dirt, such as water containing a lot of minerals and small sand that has accumulated. To fix this, open the hole where the water comes out using a wrench. Then, clean the water filter and the rubber inside. There may be sediment or residual dirt that has been filtered out.
GB Sanitaryware jet washer GBSN9-CR. (Doc/GB Sanitaryware)
4. If the jet washer head is crusted
This problem generally occurs on washer jets made from or coated with stainless steel. This is normal because the washer jet often comes into contact with water and is not cleaned immediately. For this reason, use a jet washer with the best material, such as stainless steel SUS 304 or brass like the jet washer GB Sanitaryware. You can also use chrome cleaning fluid to clean the water scale that sticks to the surface of the washer jet.
Hopefully, the information is useful, yes!
Written by : Nathasya Elvira
